BO616SS 60 cm Built in fan oven BO628SS 60 cm Built in multifunction oven BO636SS 60 cm Built in multifunction oven lxa, 1
User Manual for your Baumatic BO616SS 60 cm Built in fan oven BO628SS 60 cm Built in multifunction oven BO636SS 60 cm Built in multifunction oven NOTE: This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any person not familiar with the operation of the appliance.
Contents Environmental note 4 Important safety information 5–7 Specifications BO616SS BO628SS BO636SS Cooling fan Control panel Oven programmer/timer 8 – 12 8 9 10 11 11 12 Initial set up of your oven Setting the time of day Before first use 12 – 13 12 13 Timer functions The minute minder function The semi-automatic cooking function The end of cooking function The automatic cooking function Cancelling the semi-automatic and automatic function Cancelling the minute minder function Adjusting the volum
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line. General Information o This appliance is designed for domestic household use and can be built into a standard kitchen cabinet or housing unit.
Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch the appliance at any time. o If it is necessary for younger family members to be in the kitchen, please ensure that they are kept under close supervision at all times. General Safety o Do not place heavy objects on the oven door or lean on the oven door when it is open, as this can cause damage to the oven door hinges.
Installation This appliance must be correctly installed by a suitably qualified person, strictly in accordance with the manufacturer’s instructions. o Baumatic Ltd. declines any responsibility for injury or damage, to person or property, as a result of improper use or installation of this appliance. o Heat, steam and moisture will be created during use of the appliance, take care to avoid injury and ensure that the room is adequately ventilated.
Specifications BO616SS Product Dimensions Height: Width: Depth: 600.3 mm 598 mm 565.
Mains Supply Lead: BO628SS 3 x 1.5mm² Product Dimensions Height: Width: Depth: 600.3 mm 598 mm 565.
Mains Supply Lead: 3 x 1.5mm² BO636SS Product Dimensions Height: Width: Depth: 600.3 mm 598 mm 565.
Supply Connection: Max Rated Inputs: Mains Supply Lead: Cooling fan 13 A (double pole switched fused outlet with 3mm contact gap) 2.15 – 2.55 kW 3 x 1.5mm² o A tangential cooling fan is fitted inside of these appliances, to make the internal temperature of the oven stable and the external surface temperature lower. o After you have finished cooking and switched off the oven, the cooling fan will continue to run for a period of time afterwards.
Oven programmer/timer 1 2 3 4 5 6 7 = = = = = = = Automatic cooking symbol Oven in use symbol Decimal point symbol Minute minder symbol Minus button Programme button Plus button Initial set-up of your oven Setting the time of day After your appliance is connected to your mains supply for the first time, you must set the time of day before you can use the oven.
Before first use o To remove any residue from the oven that may have been left from the manufacturing process, you should select the fan oven function (conventional oven for BO628SS) and set the thermostat to its maximum temperature setting. o It is perfectly normal for a smell to be produced during this process. o You should make sure that any windows in the room are left open during this process. o It is advisable for you not to remain in the room whilst the burning off process is taking place.
Timer functions The minute minder function The minute minder function is a countdown time that can be set on the oven programmer/timer. When the countdown time has finished, an audible signal will sound. o Press and hold down the programme button (6) until the decimal point starts to flash to enter programming mode. o Use the plus (7) and minus (5) buttons to set the countdown time that you require. o The maximum countdown time that can be set is 23 hours and 59 minutes.
The semi-automatic cooking function This function will allow you to set a countdown time similar to the minute minder function, however the oven will switch off at the end of the cooking time. o Place the food that you want to cook inside of the oven and close the door. o Select an oven function and cooking temperature using the relevant control knobs.
The end of cooking function This function is similar to the semi-automatic function, however instead of setting a countdown time, you select the time of day that you want the oven to switch off at. o Place the food that you want to cook inside of the oven and close the door. o Select an oven function and cooking temperature using the relevant control knobs.
o IMPORTANT: If you have not turned the oven function selector knob and thermostat control knob to their OFF positions, when you reset the oven it will continue to heat. The automatic cooking function This function will allow you to set the time of day that you want the oven to switch off at and how long you want the oven to cook for. o Place the food that you want to cook inside of the oven and close the door. o Select an oven function and cooking temperature using the relevant control knobs.
o At the end of the cooking time, an audible signal will sound and the automatic cooking symbol will flash on the LED display. o To reset the oven and cancel the audible alarm, press the programme button until the oven in use symbol appears on the LED display and the automatic cooking symbol goes out. o IMPORTANT: If you have not turned the oven function selector knob and thermostat control knob to their OFF positions, when you reset the oven it will continue to heat.
o Press the programme button (6) and the LED display will show “n” followed by a number. 1 is the loudest volume, 2 is the middle volume and 3 is the quietest volume. o Use the minus button to select the volume level that you desire. Changing the time of day o IMPORTANT: The oven timer/programmer must not be in any form of countdown mode and the oven in use symbol (2) must be lit. o Press and hold down the minus (5) and plus (7) buttons simultaneously until the decimal point starts to flash.
FULL GRILL (BO636SS): This method of cooking utilises the inner and outer parts of the top element, which directs heat downwards onto the food. This function is suitable for grilling medium or large portions of sausages, bacon, steaks, fish etc. DEFROST MODE (BO616SS, BO636SS): The fan runs without heat to reduce the defrosting time of frozen foods. The time required to defrost the food will depend on the room temperature, the quantity and type of food.
The light will turn off when the temperature set on the thermostat control knob has been reached. It will cycle on and off throughout the cooking time. You should not place food inside the cavity, until the correct cooking temperature has been reached. Cooking guidelines o Please refer to the information given on food packaging for guidance on cooking temperatures and times. Once familiar with the performance of your appliance, temperatures and times can be varied to suit personal preference.
Warnings o Keep the oven door closed when using any of the cooking functions, including all grill functions. o Do not use aluminium foil to cover the enamelled baking tray or heat items wrapped in aluminium foil under the grill. The high reflectivity of the foil could potentially damage the grill element. o You should also never line the base of your oven with aluminium foil. o During cooking, never place pans or cookware directly onto the bottom of your oven.
Cleaning and maintenance Cleaning operations must only be carried out when the oven is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process. o The oven should be thoroughly cleaned before it is operated for the first time and after each use. This will avoid residual food stuffs becoming baked on the oven cavity. After residues have been baked on several times, they are far more difficult to remove. o Never clean the oven surfaces by steam cleaning.
o Any damage that is caused to the appliance by a cleaning product will not be fixed by Baumatic free of charge, even if the appliance is within the guarantee period. Replacing the oven bulb IMPORTANT: The oven must be disconnected from your mains supply before you attempt to either remove or replace the oven bulb. o Remove all oven shelves enamelled baking tray. and the o Remove the light cover by turning it anti-clockwise. o Unscrew the bulb clockwise and remove it from its holder.
Removing the oven door for cleaning To facilitate the cleaning of the inside of the oven and the outer frame of the oven, the door can be removed as follows:o The hinges (A) have two movable bolts on them (B). o If you raise both of the movable bolts (B), then the hinges (A) are released from the oven housing. o You should grip the sides of the door at the centre and then incline it slightly towards the oven cavity and then pull it gently away from the oven cavity.
o Do not immerse the door in water at any time. Removing the inner door glass for cleaning o To facilitate cleaning, the door glass can be lifted out. o Open the door of the oven to a 45° angle. o There is a plastic sealing section at the top of the oven door, which has 4 small slots in it. o Place a coin horizontally into one of the small slots and rotate the coin clockwise. You will feel part of the plastic sealing section disengage from the door.
o This will allow you to access the inner door glass. Carefully lift the door glass slightly at the top of the oven door and then slide the door glass towards you, removing it from the oven door. o IMPORTANT: Be careful to note which way around the oven door glass sits inside the oven door. YOU MUST put the door glass back into the oven door the same way around.
o This appliance should be wired into a 13 A double pole switched fused spur outlet, having 3 mm contact separation and placed in an easily accessible position adjacent to the appliance. The spur outlet must still be accessible even when your oven is located in its housing. o To connect the oven power cord, loosen and remove the cover on the terminal block, in order to gain access to the contacts inside.
Positioning the appliance o Ensure that the aperture that you will be fitting the oven into is of the size given in the above diagram. o The oven must be fitted into an oven housing with the ventilation cut-outs shown in the “Ventilation requirements” section on the next page. o Ensure that the rear panel of the furniture housing unit has been removed.
Ventilation requirements (Figure shows the ventilation and cut-out requirements for the installation of the appliance into a standard kitchen unit). (Figure shows the ventilation and cutout requirements for the installation of the appliance into a tall housing unit).
Installing the oven into the housing unit o IMPORTANT: Before installing the appliance into the housing unit, YOU MUST attach the “drip catcher” to the lower front edge of the oven using the 3 screws supplied. The above line drawing shows how you attach the “drip catcher”. o Ensure that the oven has been securely fixed into the housing unit. The fixing of the oven into the housing is made by using four screws and caps, which are supplied with the oven.
My appliance isn’t working correctly o The oven isn’t coming on. * Check that you have selected a cooking function and a cooking temperature. * Check that the automatic cooking symbol (1) isn’t lit on the LED display. o There appears to be no power to the oven and grill. * Check that the appliance has been connected to the electrical mains supply correctly. * Check that the mains fuses are in working order. o The grill function works but the main oven does not.
* Refer to page 23 and follow the “Replacing the oven bulb” section. o I am getting condensation in my oven. * Steam and condensation is a natural by product of cooking any food with high water content, such as frozen food, chicken etc. * You may get condensation in the oven cavity and forming between the oven door glasses. This is not necessarily a sign that the oven is not working correctly. * Do not leave food in the oven to cool after it has been cooked and the oven has been switched off.
IMPORTANT: Baumatic Ltd. operates a policy of continuous improvement and reserves the right to adjust and modify its products without prior notification.
United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Czech Republic Baumatic CR spol s.r.o. Průmyslová zóna Sever 696 460 11 Liberec 11 Czech Republic Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Customer Care Telephone (0118) 933 6911 Customer Care Fax (0118) 986 9124 Spares Telephone (01235) 437244 Advice Line Telephone (0118) 933 6933 www.baumatic.cz E-mail: sales@baumatic.co.uk customercare@baumatic.co.uk spares@baumatic.co.
