User manual

Gas Safety (Installation and Use) Regulations
o It is a legal requirement that all gas appliances are installed by
competent persons in accordance with the current edition of the
Gas Safety Installation and Use Regulations.
o For reasons of safety, it is in your best interests to ensure
compliance with the law.
o In the UK, GASSAFE registered installers work to safe standards
of practice. The cooker must also be installed in accordance with
the current edition of BS 6172. Failure to install the oven
correctly could invalidate the warranty, liability claims and lead
to prosecution.
Gas connection
ALL INSTALLATION AND SERVICE WORK MUST BE
CARRIED OUT BY A GASSAFE REGISTERED
ENGINEER.
34
o Prior to installation, ensure that the gas supply conditions
(nature of the gas and gas pressure) and the adjustment
conditions are compatible. The adjustment conditions for this
appliance are stated on the rating plate which can be found on
the back cover.
o This appliance is not designed to be connected to a combustion
product evacuation device. Particular attention should be given
to the relevant requirements regarding ventilation.
o A ½” BSP female to female gas
elbow (not supplied) should be
connected to the gas inlet at the
rear of the appliance and
pointing in a downward direction.
As indicated in the diagram
opposite.
o IMPORTANT: FIBRE WASHERS MUST
BE USED WHEN
CONNECTING THE GAS ELBOW (AS SHOWN IN THE ABOVE
DIAGRAM).
o Connection to the cooker should be made with an approved
appliance flexible connection to BS 669.