User manual

12
nitial set-up of your oven I
Setting the time of day
After your appliance is connected to your mains supply for the first
time, you must set the time of day before you can use the oven.
o When the oven is connected to your mains supply for the first
time (or after a power cut), the digits on the LED display and
the automatic cooking symbol (1) will flash.
o Press and hold down the programme button (6) for a couple of
seconds. The automatic cooking symbol will go out and the
digits will remain steady.
o Whilst the decimal point symbol (3) is flashing, use the plus (7)
and minus (5) buttons to set the correct time of day.
o When the correct time of day is shown on the LED display,
ew seconds. The
t symbol will stop flashing and the oven is ready to
g process, you should select the
temperature setting.
f process is taking place.
should be used.
release the plus and minus buttons and wait a f
decimal poin
use.
Before first use
o To remove any residue from the oven cavities that may have
been left from the manufacturin
fan oven function for the main oven and the conventional oven
function for the top oven. Separately set each oven to its
maximum
o It is perfectly normal for a smell to be produced during this
process.
o You should make sure that any windows in the room are left
open during this process.
o It is advisable for you not to remain in the room whilst the
burning of
o You should leave each oven on maximum setting for 30 – 40
minutes.
o IMPORTANT: You should not burn off both ovens
simultaneously.
o After the oven cavities have cooled, they should then be cleaned
with warm soapy water, using either a sponge or soft cloth. No
abrasive cleaners