User manual

27
m when removing the door, as the
echanism has a strong spring.
Do not immerse the door in water at any
o Take care not to dislodge the hinge locking
syste
hinge m
o
time.
LATION INSTAL
The installation must be carried out by a suitably
ualified person, in accordance with the current
ued by the Scottish Development
IEE Wiring Regulations.
nnecting the appliance, make sure that the supply voltage
arked on the rating plate corresponds with your mains supply
essible position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located in
its housing.
inside. Make the connection, securing the cord in place with the
q
version of the following.
o UK Regulations and Safety Standards or their European Norm
Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Standards (iss
Department).
o
o Electricity At Work Regulations.
Before co
m
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 20 A double pole switched
fused spur outlet, having 3 mm contact separation and placed in
an easily acc
o To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
cable clamp provided and then immediately close the terminal
block cover again.