User manual

18
Fitting the Décor Door
2) Fix the hanging
rail onto the inside
of the décor door
using two 10mm
screws, centering it
so that 262mm of
its width is on either
side of the
imaginary vertical
middle line of the
décor door.
1) Using a 2.8mm
diameter bit, make
holes sufficient to
attach the rail as
shown on the left.
NOTE – door area
below the rail
must reach to just
below appliance.
NOTE:
You need
the tools
shown
here.
3) Clasp the eyelet holes
in the rail on the inside
of the décor door over
the bolts protruding from
the top edge of the
refri
g
erator door. Secure
these using the nut caps
provided, as shown in
the above illustration.
Make sure that you have
the décor door attached
levelly before proceeding
to the lower fastenings
as shown on right.