User manual

22
Use a spanner to adjust the height of the adjustable feet.
of 820 mm, then the adjustable
feet should be fully tightened.
m, then the adjustable
feet should be set at a height of 50 mm.
door and door seal may be affected.
ight, depending on the height that you
have set your appliance.
and then refit the grid in its original
position to hold it in place.
tion cut MUST be
made in the furniture plinth/kickboard.
o
o If your aperture has a height
o If your aperture has a height of 870 m
o The appliance should be flush with the underside of the worktop
and be level. IMPORTANT: If the appliance is not level, then the
o A cut out must be made in the plinth/kickboard for ventilation.
The cut out should measure 600mm in width, and between
140mm and 90mm in he
o Insert the plinth/kickboard
o IMPORTANT: Please note that as shown in the above
drawing, an appropriately sized ventila