User manual

23
9) Replace the fridge door and the middle hinge.
10) Replace the freezer door and the lower hinge.
11) Check that the doors are properly aligned and both door seals
make contact with the appliance at all points before tightening up all
the screws and bolts.
12) Return the fridge freezer to its upright position. If necessary, the
hinge positions can be adjusted to ensure the doors are level and
efficiently sealed.
Positioning
o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN +10 to +32 degrees centigrade
N +16 to +32 degrees centigrade
ST +18 to +38 degrees centigrade
T +18 to +43 degrees centigrade
o Positioning the appliance requires two people in order to avoid
injuries or damage to the appliance.
o Keep a minimum of 100 mm between your refrigerator and the
back wall. There should also be a gap of 100 mm either side. If
there is insufficient space this can create the sound of vibration,
weakening of the refrigerator’s power and a waste of electricity.
o The appliance should never be placed upside down or carried in a
horizontal position.
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not possible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o Place the appliance flatly and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, which
can be used to level the appliance.