User manual

25 25
NSTALLATION I
The installation must be carried out by a suitably
qualified person, in accordance with the current
ued by the Scottish Development
tions.
n the rating plate corresponds with your mains supply
be accessible even when your oven is located in its
housing.
rovided and then immediately close the terminal block cover
onductor must always be 10 mm longer than the
the temperature of the mains
btained from the Spares
version of the following.
UK Regulations ano d Safety Standards or their European
Norm Replacements.
Building Rego ulations (issued by the Department of the
Environment).
Building Stao ndards (iss
Department).
o IEE Wiring Regulations.
o Electricity At Work Regula
Electrical connection
Before connecting the appliance, make sure that the supply voltage
marked o
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 13A double pole switched
fused spur outlet, having 3 mm contact separation and placed in an
easily accessible position adjacent to the appliance. The spur outlet
must still
o To connect the oven power cord, loosen and remove the cover on
the terminal block, in order to gain access to the contacts inside.
Make the connection, securing the cord in place with the cable
clamp p
again.
o If you have to change the oven power cord, the earthing
(yellow/green) c
line conductors.
Care must be taken to ensure that o
supply cable does not exceed 50°C.
o If the mains supply cable is damaged, then it must be replaced by
an appropriate replacement which can be o
Department.