User manual

Instructions for use, installation and connection
25
Troubleshooting guide
Any unskilled attempt to repair the
appliance is extremely dangerous as it
might cause electric shock and short
circuit. To avoid such injuries any repairs
may be performed only by qualified
personnel, or after sales service.
Before attempting any repairs disconnect
the appliance from the mains by
removing the fuse or unplugging the
mains lead from the mains socket.
Note!
There are, however, some minor faults
which may be easily removed by the
user, in accordance with the instructions
that follow.
Important!
If the malfunction of the appliance was
caused by the improper use, the service
visit during the warranty period is not
free of charge.
Following are some simple advice
how to repair minor faults:
Signal lamp does not turn on....
x are all the required switches properly
activated?
x is the mains power fuse burned?
x is the temperature regulator properly set?
Fuses often burn out...
x Call the serviceman or your electrician!
Oven illumination is not on....
x Exchange of oven bulb is described in
the section "Replacement of parts".
Oven does not heat up...
x is the mains power fuse burned?
x is the temperature regulator set
correctly?
Baking results are
disappointing...
x did you remove the grease filter?
x did you follow the instructions and
warnings from the section "Baking"?
x did you strictly follow the information from
the Baking table?
Burners do not burn
uniformly…
x Gas serviceman should check the gas
settings!
Burner flame suddenly changes,
burners require excessive
ignition time…
x Assembly the burner components
correctly!
Flame goes off immediately
after ignition…
x Keep the button pressed somewhat
longer.
x Push firmly once more before releasing
the button.
Burner grid has changed color
in the burning area…
x This is a normal consequence of high
temperature; clean the grid with metal
cleaner.
Electric ignition of gas is
malfunctioning, burner covers
are dirty…
x Carefully clean the gap between the
ignition spark and the burner.
x Clean the covers with a metal cleaning
agent.