User manual

Instructions for use, installation and connection
30
Gas connections
x Gas cooker is equipped with the gas
connection on the right side with the
exterior thread ISO 7-R1/2.
x Certain appliances are supplied with the
attached liquid gas coupling and the
sealing gasket.
x The connection R1/2 must be gripped
tight during the connection procedure to
prevent it from revolving.
x Use metal or non metal gaskets for
connection packing. Gaskets are
intended for single use only.
x To provide sufficient connection tightness
screw the nuts with the moment of 30
Nm.
x The deformation of the non-metal gasket
connection thickness during tightening
may not exceed 25%.
x Connect the appliance to the gas
coupling by means of certified flexible
hose. The hose may not touch the
bottom panel of the appliance or the rear
panel and ceiling of the oven.
x Connect the appliance in accordance
with the regulations of the local gas
supplier.
Important! Check all the connections
for tightness after the installation!
Beginning of operation
Start using the appliance in accordance
with the instructions for use.
Lit up all burners and check the stability
of the flame with high and low setting.
Adjust air intake if necessary.
After that, take time and explain the
operation and control of the appliance to
the user and read with him the
instructions for use.
Liquefied gas connection
9 Pipe coupling
for liquefied
gas
10 Gasket
11 R 1/2
connection