Operation Manual

7) Insert the expansion fixings (rawlplugs) provided, put support

bracket ‘G’ (see top Figure on previous page) in position and

secure it with the screws provided.

8) Lift casing ‘B’ up to the ceiling and secure it to the bracket ‘G’,

inserting the screws provided in the side holes of the support

bracket and then tightening them.

_____________________________________________________

ATTACHING THE GLASS

9 Remove the metal grease filters from

the hood (see Figure on bottom right).

9 Slacken both anchoring screws

‘F’ (respectively on the left and right).

9 Remove the anchoring corner

marked with the letter ‘Z’, pulling it

upwards.

9 Place the glass ‘Q’ on the upper

shelf of the hood, pushing it in

towards the wall.

9 Insert the anchoring corner ‘Z’ onto

the short side of the unit, tightening

the screws ‘F’ again in the hole and

connecting them to the unit.

PLEASE NOTE* DO NOT

OVERTIGHTEN THESE SCREWS OR

YOU MAY DAMAGE / DISTORT THE

UNIT!

9 Take care that the anchoring corner

is firmly fastened, tightening it well.

Re-insert the metal filters.

9 Connect the ventilation tube

with the coupling tube ‘N’

(Fig. 1 – see next page).

INSTALLATION INSTRUCTIONS – Fittin

the Pi