BTD1 Fully integrated airvented tumble dryer
USER MANUAL FOR YOUR BAUMATIC BTD1 Fully integrated airvented tumble dryer NOTE: This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference.
Contents Environmental note 4 Important safety information 5–7 Specifications Product and aperture dimensions Product specifications Electrical details Control panel 8 – 10 8 8–9 9 9 - 10 Drying program guidance Care labels 10 – 11 11 Selecting a drying program Pausing a drying cycle 12 12 Maintenance and cleaning In daily use Control panel and tumble dryer cabinet The tumble dryer drum Door The filter 13 - 14 13 13 13 13 14 Installation Installing the appliance into a kitchen unit Reversing the
Environmental note Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. Disable the door lock to make sure that children cannot get stuck inside the appliance. o The packaging materials that Baumatic uses are environmentally friendly and can be recycled.
Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line. General Safety o Repairs to your appliance must only be carried out by a Baumatic engineer or one of its authorised service agents.
o Adequate venting must be provided to avoid back flow of gases into the room from appliances burning other fuels including open fires. o Exhaust gas must not be discharged into a flue used for exhausting fumes from appliances burning gas or other fuels. o Do not allow the venting hose (where applicable) or filter to become blocked. During Use o It is recommended that the appliance is turned off after the machine is used. o This appliance is only designed to dry normal domestic washloads.
o DO NOT place items in the dryer if anything other than a water solution has been used in the cleaning process. o DO NOT attempt to dry dripping wet items. Child Safety o The tumble dryer is not intended for use by persons with reduced mental, physical or sensory capabilities or lack of experience or knowledge, unless they have been given supervision and instructions concerning the use of the appliance by a person responsible for their safety.
Specifications Product and aperture dimensions Appliance dimensions Aperture dimensions Height: Height: 820 mm Width: Depth: 600 mm 600 mm Width : Depth: 820 - 850 mm (excluding décor strip) 595 mm 530 mm Product specifications o o o o o o o o o o o o Capacity: 6 kg 6 drying programs Adjustable heat input Minute minder up to 140 minutes Reverse tumble action 180° door opening 300 mm porthole diameter Removable fluff filter Galvanized drum Safety lock Anti crease function Venting hose 8
o Adjustable feet o Energy efficiency class: C Electrical details Rated voltage: 220 - 240 Vac 50 Hz Electrical connection rating: 2.70 kW Supply connection: 13 A (double pole switched fused outlet with 3 mm contact gap) Control panel A B C D Drying time selection knob Program suggestion display Heat selection button Start button Drying time selection knob o Turning the control knob allows you to select the drying time according to your laundry.
Linens Polyester cotton 80 – 120 40 - 60 Heat selection button o Press this button to select the temperature that you require for a particular wash program. Low heat High heat Start button o Once a drying program has been selected, this button should be pressed to start the drying cycle. Drying program guidance o Check the wash care labels of the garments that you want to dry, to make sure that they are suitable for drying in a tumble dryer.
o DO NOT dry clothes containing foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads in the appliance. o DO NOT dry one item at a time as the garment will roll up and increase the drying time. o IMPORTANT: If the clothes become dry before the cycle has finished, the thermostat will automatically switch off the heater to prevent over-drying the garments. This will save energy although the drum will still rotate.
Selecting a drying program o Open the tumble dryer door. o Load the clothes loosely into the drum. Items such as sheets should be loaded corner-first. o Close the door and dry your hands thoroughly. o Select the desired drying temperature using the heat selection button (C). Use the program suggestion display (B) as a guide. o Check that the drying time selection dial (A) is in the “0” position before you adjust it to the required drying time.
Maintenance and cleaning In daily use o The filter should be cleaned after each drying cycle. o Leave the porthole door ajar for a short while after a drying cycle has completed. This should help to prevent stagnant smells and to protect the door seal. o We suggest that you disconnect the appliance from your mains supply, when it is not in use. Control panel and tumble dryer cabinet. IMPORTANT: Do not use any abrasive cleaner or household polish on either the control panel or operating parts.
The filter o It is important to remove fluff from the filter after each drying cycle. o You should disconnect the appliance from the mains supply before cleaning the filter. o The filter is located inside the doorway rim at the bottom, as shown in the above diagram. o To remove the filter, pull it upwards. o Remove any thread or fluff by hand or with a soft brush. o Slide the filter back into position.
Installation IMPORTANT: THIS INSTALLATION MUST BE COMPLETED BY A SUITABLY QUALIFIED PERSON. BAUMATIC ONLY SANCTION THE INSTALLATION GIVEN IN THIS INSTRUCTION MANUAL. YOU SHOULD KEEP THE TRANSIT PACKAGING, IN CASE YOU NEED TO TRANSPORT THE MACHINE IN THE FUTURE. Installing the appliance into a kitchen unit o You should ensure that the size of the aperture is the same as the dimensions given in the above diagram. o Your dryer is provided with a vent hose which will extend to approximately 2.4 metres.
o The vent hole should be positioned 125 mm in from the left adjacent kitchen unit and 695 mm below the work surface above. o If the vent through the wall is to be positioned anywhere else other than behind the dryer, the vent hose should be located at floor level and through an adjacent side panel to a suitable position. o The plinth must be cut-out to accommodate the air vent grill at the bottom front of the tumble dryer. The cut-out size required is shown in the diagram below.
Reversing the dryer door IMPORTANT: The appliance must be disconnected from the mains supply before carrying out this procedure. o The tumble dryer’s door can be positioned to open either to the right or the left. o Open the dryer door. o Undo the screw (A), remove the switch strike (B) and replace the screw. o Remove the screws (C) and latch plate (D). o Remove the hinge cover screw (E). o Close the door.
o Pull the hinge cover (F) forwards to remove it. o Remove the two outer screws (G). Remove the door. o Fit the latch plate (D) with screws (C). o Reverse the door and place against the dryer’s doorway so that it is in the closed position. o Refit the screws (G) and hinge cover (F). o Open the door. o Fit screw (E) to secure the hinge cover. o Remove the screw (A) at the top of the door and refit strike (B) as shown in the above drawing.
Fitting the décor door o The hinges can be fastened through the pre-drilled holes on either the left or right hand side with the door stops being fitted on the other side. o The décor door and dryer door must be hinged on the same side. The décor door must not be sliding or lockable. o PLEASE NOTE: The drawing above shows a décor door incorporating a false drawer front.
o IMPORTANT: As your appliance is a built in product, the electrical socket or mains switch must still be accessible once the appliance is installed. o Consult the rating plate, located on the back of the appliance BEFORE making the electrical connections. Ensure that the voltage reaching the plug is the same as that on the rating plate. o DO NOT REMOVE THE RATING PLATE AS THE INFORMATION ON IT IS IMPORTANT.
Troubleshooting o If your tumble dryer appears to have a fault, please check the table below before calling the Baumatic Customer Care Helpline. Problem Clothes are not dry after a normal drying time (e.g. a length of time within which your appliance usually dries a similar washing load). Your tumble dryer is not working at all. Possible cause The filter is dirty. You used the wrong temperature setting. The power is off.
IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact Baumatic Customer Care on telephone number (0118) 933 6911. IMPORTANT: DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. Please note that if an engineer is asked to attend whilst the product is under guarantee and finds that the problem is not the result of an appliance fault, then you may be liable for the cost of the call out charge.
United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Czech Republic Baumatic CR spol s.r.o. Průmyslová zóna Sever 696 460 11 Liberec 11 Czech Republic Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Customer Care Telephone (0118) 933 6911 Customer Care Fax (0118) 986 9124 Spares Telephone (01235) 437244 Advice Line Telephone (0118) 933 6933 www.baumatic.cz E-mail: sales@baumatic.co.uk customercare@baumatic.co.uk spares@baumatic.co.
39