User manual

Troubleshooting
o If your tumble dryer appears to have a fault, please check the
table below before calling the Baumatic Customer Care Helpline.
Problem Possible cause Possible solution
The filter is dirty. Clean the filter.
You used the wrong
temperature
setting.
Increase the temperature setting.
The power is off. Check if the power is on or not.
The venting hose
has become
blocked
(sometimes a
strong wind may
cause back
pressure).
Unblock the venting hose.
Clothes are not dry
after a normal
drying time (e.g. a
length of time within
which your appliance
usually dries a
similar washing
load).
You have set the
timer within the
cool down period.
Set the timer for a long enough drying
time, taking into account the final cool
down period (about 12 minutes).
There is no power
supply.
Connect to a power supply.
Not switched on. Switch on the machine.
The door is not
closed properly.
Close the door before trying to operate
your appliance again.
Your appliance has
cut-out.
Your tumble dryer has been fitted with
a resettable cut-out. Check that this is
not engaged by seeing if the red button
on the back of your appliance gives a
sharp ‘click’ sound when you press it.
PLEASE NOTE: This cut-out only
operates if the airflow is severely
restricted so make sure the filter is
clean and all other restrictions are
removed before restarting.
Your tumble dryer is
not working at all.
The mains cord is
damaged.
You must contact the Customer Care
Helpline to order a new cord.
This label, positioned on the rear of your dryer, indicates
that the surface is hot when in use so avoid touching it.
CAUTION HOT
SURFACE
21