User manual

5) If you are going to be using
the hood in extraction mode, you
should fit the spigot for the duct
hose onto the main body of the
cooker hood, using the 4 x M4
bolts,
6) Lift the main body of the cooker hood
onto the angle bar and then fix it into
position using the 16 x M4 bolts.
o IMPORTANT: This stage of the
installation process MUST be
completed by two people.
o IMPORTANT: The 16 x M4 bolts
MUST be securely tightened.
8) If you are going to be using the hood in
extraction mode, you should fix the
ducting hose to the spigot.
o The electrical connection must
correspond to the electrical
requirement noted on the rating
plate, which is placed inside the
cooker hood. The appliance should
now be connected to the electrical
supply. See pages 15 - 16 for
detailed information on the electrical
connection.
o Check that the appliance is operating correctly by selecting each
speed and switching the light bulbs on and off.
o Remove the hanging hook and then slide the lower chimney
section downwards, until it rests against the main body of the
cooker hood.
o Use a stainless steel cleaner and polish on the stainless steel
sections of the appliance.
21