User manual

12
Switching on the appliance and setting the temperature
o Press the power button to switch the appliance on.
o If the appliance is being switched on for the first time, or after it
has been disconnected from the power supply, the LED display
will show the factory pre-set temperature of +12°C.
o Use the temperature increase and
temperature decrease buttons to set the
temperature that you require. Each press
of these buttons will adjust the temperature on the LED display
by one degree.
o Whilst you are setting the temperature of the cooling zone, the
LED display will flash. When you stop pressing the temperature
buttons, after 3 seconds the display will stop flashing and the
temperature of the cooling zone will be set.
o The LED display will show the temperature that is currently being
registered by the cooling zone.
Changing between Fahrenheit and Celsius
o You can select whether the LED display shows Celsius
or Fahrenheit by pressing and holding the light control
button for about 5 seconds.
o The Celsius / Fahrenheit indicator neons will light to show
whether Celsius or Fahrenheit is currently shown.
o You cannot change the display if you are in the process of
adjusting the temperature of the cooling zone (i.e. the display is
flashing).
Interior light
o To operate the interior light, you should use the light
ON/OFF button.
o You cannot operate the interior light if you are in the process of
adjusting the temperature of a cooling zone (i.e. the displays are
flashing).