User manual

21
Troubleshooting
IMPORTANT: If your wine cabinet appears not to be
operating properly, before contacting the Baumatic
Customer Care Department, please refer to the
checklist below.
PROBLEM POSSIBLE CAUSE
Appliance does not operate. Not plugged in.
The circuit breaker has tripped or the
fuse has blown.
Temperature inside the appliance is too
warm.
The temperature controls are set too
warm. Set the temperature controls to a
cooler setting and allow several hours for
the temperature to stabilise.
The door is being kept open too long or is
being opened too frequently, which is
allowing warm air to enter the appliance.
The door is not closed completely.
The door gasket is not sealing correctly.
The appliance has recently been
disconnected from the mains supply; it
will take at least four hours for it to get
down to temperature again.
Temperature inside the appliance is too
cold.
The temperature controls are set too
cold. Set the temperature controls to a
warmer setting and allow several hours
for the temperature to stabilise.
Vibration. Check to ensure that the appliance is on
a level surface.
The appliance is touching the back wall
behind it. Reposition the appliance and
move it from the wall.
If vibration continues to occur, then turn
off the appliance and unplug it from your
mains supply. Then contact the Baumatic
Customer Care Department for
assistance.
Moisture is forming on the inside of the
appliance.
The door is slightly open.
The door is being kept open too long or is
being opened too frequently. Open the
door less often.
The door is not sealed properly.
Moisture is forming on the outside of the
appliance.
The door is slightly open, causing cold air
from inside the appliance to meet warm,
moist air from the outside.
Abnormal display on the control panel. LO on the LED display indicates that the
temperature of the appliance is too low.
You should use the temperature increase
button to adjust the temperature.
HL on the LED display indicates that the
temperature of the appliance is set too
high. You should use the temperature
decrease button to adjust the
temperature.