User manual

26
Door gasket
9 You should regularly check to see if any deposits have
formed, or there are any foreign bodies in the rubber door
gasket. This sits inside the opening of the porthole door.
Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear in the LCD display.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTENANCE ON THE APPLIANCE,
IT SHOULD BE DISCONNECTED FROM YOUR MAINS POWER
SUPPLY.
No display
o Power failure.
o Check that the power plug is in the mains socket correctly.
o Check the mains fuse.
F01- No water coming into the machine
o Check the water pressure of your mains water supply.
o Clean the mesh filter that sits in the inlet hose.
o Make sure the water tap that the machine is connected to is turned
on fully.
F02- The machine will not drain or spin
o Clean the drain pump filter.
o Check the drain hose is not blocked or kinked.
F04- The machine does not start
o Check that the door has been shut properly before commencing a
wash cycle.
C03- The machine has sensed an out of balance load
o This may be due to uneven distribution of clothes in the drum,
which may cause an excessive level of vibration.
o See the “General troubleshooting” section.
F05 – F10- Contact Baumatic Service Department
Once the machine has been plugged back into your mains power
supply, to clear the fault code from the LCD display, you should turn
on the machine and hold down the Start/Stop button for approximately
5 seconds.