User manual

17
will proceed to carry out a pre-wash followed by a standard
cotton and linen wash cycle.
o Press the start / pause button (G) to begin the wash cycle.
o If you press the extra rinse button (J) before the cycle starts,
the machine will add this function to your wash program.
o Before you start the cycle you can also adjust the spin speed and
wash temperature by pressing the relevant buttons.
Setting a dry cycle only
o Press the ON / OFF button (A).
o Rotate the program selection dial (B) to set the required
program. Drying only cycles available are Dry, Iron and Air
wash.
o Press the start / pause button (G) to begin the drying cycle.
o The final part of a drying cycle is a cooling cycle without
heat to ensure that the dried items are left at a
temperature that keeps them undamaged.
Pausing a wash program
o If you want to pause a wash program temporarily, you should
press the start / pause button (G).
o When you want to restart the wash cycle, press the start / pause
(G) button again.
Delay start feature
Your appliance has a delay start feature, which allows you to delay the
start of a wash cycle until a later time.
o Put the laundry into the drum and close the door.
o Press the delay start button (K) repeatedly before starting the
program to enter the time you want the machine to be finished
by.
o The start time can be delayed from 30 minutes to 24 hours. By
pressing the button the time will increase in 30 minute intervals.