User manual

29
r
p.
o Remove the filter and
rinse out the filter unde
the ta
o Remove any debris from
the filter.
o Remove any debris that is in the area of the appliance that you
removed the drain pump filter from.
o Screw the filter clockwise back into position, making sure that it
is fully tightened. You should keep turning until you cannot turn
it any further.
o IMPORTANT: Do not perform this operation if the
appliance has stuck on a cycle, until the water inside of
the machine has cooled sufficiently. Otherwise the water
that comes out of the drain pump filter may still be hot.
Installation
IMPORTANT: THIS INSTALLATION MUST BE
COMPLETED BY A SUITABLY QUALIFIED PERSON.
BAUMATIC ONLY SANCTION THE INSTALLATION
GIVEN IN THIS INSTRUCTION MANUAL. YOU
SHOULD KEEP THE TRANSIT PACKAGING, IN CASE
YOU NEED TO TRANSPORT THE MACHINE IN THE
FUTURE.
Unpacking the machine and removing the transit bolts
IMPORTANT: The transit bolts MUST be removed before your washer
dryer is used for the first time.
o Remove the back plate
from the rear of the
appliance.