User manual

o If IE, LE, OE or UE are displayed on the LED display, you should
turn the appliance off using the POWER button and then switch it
back on again using the POWER button.
o If PFE is displayed on the LED display, you should turn the
appliance off using the POWER button, switch it back on again
using the POWER button, press the SPIN button and then press
the START/PAUSE button.
If a fault code reappears after following the
above advice and clearing the fault code. You
should turn the washer dryer off using the
POWER button. Disconnect the appliance
from your mains supply. Then arrange for an
engineer to attend the appliance. You should
contact the Baumatic Customer Care
Department on [phone].
38