Washing machine Instructions for use BWMI1262DN1 BWMI1472DN1
Introduction Please read these instructions for use carefully and all other information enclosed with the washing machine. Keep all documentation in a safe place for future reference or for any future owners. This appliances is intended to be used in household and similar applications such as: - staff kitchen areas in shops, offices and other working environments; - farm houses; - by clients in hotels, motels and other residential type environments; - bed and breakfast type environments.
Contents Page Introduction General delivery notes Safety notes Quick start Description of controls Programme Table Programme selector Detergent drawer Detergents, washing aids and amounts to use Useful advice for the user The main wash Cleaning and routine maintenance Investigating malfunctions Technical data Setting up + installation 2 4 4 5 6 12 14 17 18 20 21 23 24 26 27 BEFORE SWITCHING ON THE APPLIANCE MAKE SURE IT IS CORRECTLY INSTALLED AND THAT THE FIXING SCREWS ARE REMOVED AS SHOWN IN PAGE 27.
General delivery notes Please check that the following items are delivered with the appliance: - Instruction manual - Certificate of guarantee - Inlet hose - Liquid detergent or liquid bleach compartment Check that no damage has occurred during transit, and if so, call your nearest Authorised Technical Support Service agent. Safety notes Note: for cleaning or maintenance of the washing machine. A) Pull out the plug B) Turn off the tap C) Baumatic equips all its appliances with earthing.
M) N.B! If the appliance is installed on a carpeted floor ensure that the ventilation holes on the base of the appliance are not obstructed. N) If the appliance is not running properly or breaks down, switch it off, turn off the tap and do not tamper with the appliance. Consult only the Authorised Technical Support Service for possible repair and ask them to use original spare parts. Failure to comply with the above can compromise the safety of the appliance.
Description of controls C BF Fig. Fig.
Door handle To open the door turn the handle in the manner illustrated in fig. A B Programme Start light This lights up when the START button has been pressed. C “START/PAUSE” button Press to start the selected cycle . NOTE: When the "Start/Pause" button has been pressed, the appliance can take few seconds before it starts working.
The option buttons should be selected before pressing the "Start/Pause" button. 40 “COLD WASH” button D 30°C By pressing this button it is possible to transform every programme into a cold washing one, without modifying other characteristics (water level, times, rythmes, etc...). Curtains, small carpets, man made delicate fabrics, non coulor fast garments can be safely washed thanks to this new device.
“DELAY START” button F This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours. To delay the start use the following procedure: Set the required programme.
H “DIGITAL” Display 4 3 1 2 The display’s indicator system allows you to be constantly informed about the status of the machine: 1) SPIN SPEED Once the programme has been selected, the maximum spin speed allowed for that programme appears on the display. Pressing the spin button will reduce the speed by 100 rpm each time the button is pressed. The minimum speed allowed is 400 rpm, or it is possible to omit the spin by pressing the spin button repeatedly.
M Buttons indicator light These light up when the relevant buttons are pressed. If an option is selected that is not compatible with the selected programme then the light on the button first flashes and then goes off. PROGRAMME selector with "OFF" position N WHEN THE PROGRAMME SELECTOR IS TURNED THE DISPLAY LIGHTS UP TO SHOW THE SETTINGS FOR THE PROGRAMME SELECTED. FOR ENERGY SAVING, AT THE END OF THE CYCLE OR WITH AN INACTIVITY PERIOD, THE DISPLAY LEVEL CONTRAST WILL DECREASE. N.B.
TABLE OF PROGRAMMES PROGRAM FOR: Resistant fabrics Cotton, linen WEIGHT MAX kg Whites with Prewash 90°C + Pre 6 7 90° Fast coloureds 60°C ** 6 7 60° Fast coloureds 40°C ** 6 7 40° Non fast coloureds 30°C 6 7 30° Resistant or Mixed fabrics 30’ 2 2 30° Resistant or Mixed fabrics 44’ 3 3 40° Rinse - - - Fast spin - - - Drain only - - - Specials Cotton, mixed Very delicate fabrics Mixed fabrics and synthetics Synthetics (nylon, perlon), mixed cotton TEMP.
50°C 40°C 90°C + Pre 60°C 30°C 40°C Eco 20 °C 30°C 30’ 30°C 40°C 44’ Please read these notes ** STANDARD COTTON PROGRAMMES ACCORDING TO (EU) No 1015/2010 and No 1061/2010 COTTON PROGRAMME with a temperature of 60°C COTTON PROGRAMME with a temperature of 40°C These programmes are suitable to clean normally soiled cotton laundry and they are the most efficient programmes in terms of combined energy and water consumptions for washing cotton laundry.
Programme selector For the various types of fabrics and various degrees of dirt the washing machine has different programme bands according to: wash cycle, temperature and lenght of cycle (see table of washing cycle programmes). RESISTANTS FABRICS The Cotton programmes are designed for maximum washing and rinsing efficiency. With spin cycles in between, the programme guarantees the laundry is rinsed perfectly. The final spin cycle ensures laundry is spun dry as much as possible up to the maximum speed.
DRAIN ONLY This programme drains out the water. WOOL PROGRAMME A programme dedicated to washing fabrics labelled with the woolmark . The cycle comprises of alternate periods of activity and pauses. The programme has a maximum temperature of 40° and concludes with 3 rinses and a short spin. SPECIAL “HAND WASH” This washing machine also has a gentle Hand Wash programme cycle. This programme allows a complete washing cycle for garments specified as “Hand Wash only” on the fabric care label.
Auto half load The washing machine is fitted with a self adjusting water level system. This system enables the machine to use the amount of water needed to wash and rinse the laundry in relation to the particular load. This results in a reduction of the water and electricity used, without in any way compromising the washing and rinsing performance. In fact the amount of water and electricity used will always be appropriate for the clothes load.
Detergent drawer P The detergent drawer is split into 3 compartments: - the compartment labelled "I" is for prewash detergent; - the compartment labelled " " is for special additives, fabric softeners, fragrances, starch, brighteners etc; - the compartment labelled "II" is for main wash detergent. If liquid detergents are used, please insert the special NOTE: container supplied into the compartment marked “ II” in theSome detergent drawer.
Detergents, washing aids and amounts to use Choice of detergent General purpose detergents - - Powder detergents, for a thorough wash, with bleaching agent, particularly suitable for use in hot wash programmes (60°C and over), for heavily soiled and stained laundry. Liquid detergents, particularly suitable for grease stains, such as greasy skin marks, cosmetics and oil. These detergents are not suitable for washing stained laundry, as they do not contain bleach.
Dosages Only use detergents which are suitable for use in a washing machine. You will obtain the best results from your wash with the minimum use of chemical products and the best care for your laundry if you take into consideration the degree of soiling as well as the type of detergent to choose. The amount of detergent to use depends on: - water hardness: depending on the hardness of the water and the type of detergent used, it is possible to reduce the amount of detergent.
Useful advice for users Tips on using your domestic appliance in the most environmentally-friendly and economical way Do a full load in your washing machine To prevent any possible waste of energy, water or detergent we recommend that you put a full load in your washing machine, not exceed the recommended maximum load size.
Main wash Sorting the laundry - It is recommended you wash only items which are machine washable with water and detergent and not dry-clean items. - If you need to wash rugs, bedspreads or other heavy items, it is best not to spin them.
The correct way to wash Preparing the laundry A) Select the laundry. Loading the laundry B) Open the porthole. C) Put the laundry in the washing machine. Close the porthole again, ensuring that no items of laundry are obstructing the lock. Putting detergent in machine D) Open the drawer, choose the detergent and put in the correct amount, according to the manufacturer’s instructions and the advice on page 18. Add any other laundry aids (see page 18). Close the drawer again.
Cleaning and routine maintenance Do not use alcohol-based scourers and / or thinners on the outside of your washing machine, just a wipe with a damp cloth will suffice. The washing machine needs very little maintenance: - Cleaning the drawer compartments. - Cleaning the filter. - Cleaning the door glass. Cleaning the drawer compartments Even if it is not strictly necessary, it is good to clean the compartments for bleaching detergents and additives occasionally.
Investigating malfunctions What might be the cause of… Defects you can remedy yourself MALFUNCTION CAUSE REMEDY 1. Does not work on any programme Plug not in socket. Not switched on. Power failure. Fuse blown. Door open. Plug it in. Switch on. Check. Check. Close door. 2. Does not fill with water See cause 1. Tap turned off. Programme selector not correctly positioned. Fill hoses are kinked Check. Turn on tap. Position programme selector correctly. Straighten fill hoses 3.
Note: The use of environmentally-friendly, phosphate-free detergents can have the following effects: - waste water from rinsing may be cloudier because of the presence of zeolites held in suspension, without the rinse performance being adversely affected; - presence of white powder (zeolites) on laundry after washing, which is not absorbed by the fabric and does not alter the colour of the fabric. - The presence of foam in the final rinsing water is not necessarily an indication of poor rinsing.
Fig. 2 Technical data BWMI1262DN1 BWMI1472DN1 Max. load of dry laundry Water pressure Measurements Width Depth Height 6 kg 0,05 ÷ 0,8 MPa 7 kg 0,05 ÷ 0,8 MPa 60 cm 54 cm 85 cm 60 cm 54 cm 85 cm NB: For specifications regarding electrical data, see the data panel on the front of the washing machine (porthole area) - as shown in diagram above. Appliance complies with European Directives 73/23/EEC and 89/336/EEC, replaced by 2006/95/EC and 2004/108/EC, and subsequent amendments.
SETTING UP + INSTALLATION 1 Remove the polystyrene base and place the machine near its permanent position (diagram 1). Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2). 2 Remove the 2 or 4 fixing screws marked (A) and remove the 2 or 4 spacers marked (B) (diagram 3). Cover the 2 or 4 holes using the caps provided in the instruction booklet pack (diagram 4).
Note: we recommend you keep the screws to immobilise the machine for future transit. The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation. Water connection The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be re-used. The machine has an inlet hose with 3/4" B.S.
Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply. For the washing machine to function properly the terminal end of the discharge hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground. ELECTRICAL CONNECTIONS After installation, the appliance must be positioned so that the plug is accessible.
EN GB INSTRUCTIONS FOR INSTRUCTIONS FOR MOUNTING DOOR MOUNTING DOOR Drill holes in the door using the cardboard Drill holes in the door template as indicated in using the cardboard Fig. 1 to mount the hinges template as indicated in and magnet in Fig. 1closure to mount the hinges the or left-hand andright closure magnet in position to the rightaccording or left-hand your requirements. position accordingThe to position of the hinges your requirements. The refers to of thethe upper edge.
IT Mount the door with Montare porta with hinges byla screwing corredata dithe cerniere screws (L) to front of avvitando lemachine. viti (L) sul the washing frontale della lavabiancheria. NOTE: You are advised to mount the door so that it Nota: Ètowards consigliabile opens the left, in montare porta con il the samela direction as the senso di apertura washing machine verso load sx comefor è more l’apertura door loading dell’oblò per dare space. migliore spazio al caricamento dei panni.
gkdlfgjfldòjlf
gfdlhdhòdhkfòdkfd
dlhjdlhjògfjhkl
Baumatic 6 Bennet Road Reading Berkshire RG2 0QX United Kingdom Customer Care Telephone 0844 692 3605 Spare Parts Telephone 0844 692 3606 The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste.
