Operation Manual

EXTRA
 Ensure
union (‘N’) to the upper part of the
hood using the packaged two
scre s
(Fig
diamet
(N) on the upper part of the hood
(see Fig. 1) to the discharge outlet
for cooking vapours with a cross-
section of at least 150 cm
².
 PLEASE NOTE: If there is no
discharge outlet and the hood is to
be fitted to an outside wall of the
building, make a hole in the wall
that is large enough to fit a wind
and rain-proof shutter with a cross
section of at least 150 cm
² and
connect this to the outlet union of
the unit by means of a pipe.
__________________________________________________________________________________________________________________________________________________________________________________________________________________________
.
AIR PURIFIER (RECIRCULATION) OPERATION - Installation
Instructions
The cooker hood can be
converted to work as an air
purifier in the event that there is
no provision for an external air
discharge duct.
In this case, air is recycled through
the vent ‘R’ (Fig. 1 – above). When
using the unit as an air purifier, you
need to install two active carbon
filters to absorb cooking vapours
(please see page 11).
CTION OPERATION – Installation Instructions
that you have fitted the
ws upplied inside the packing
. 1 – on right). Using a 125 mm
er pipe, connect the union
Extraction / Air Purifier Modes of O
p
eration
Please note: For the extraction function, you
is not provided with your cooker hood. See
figure on left.
18
will need to connect a 125 mm diameter outlet
chimney to the spigot ‘N’ in fig. 1 above. This
pipe