User manual

9) Mark the position of the lower screw holes that need to be drilled
out in step 10. The holes can be found immediately below the motor
housing. (The position of one of the holes is indicated in the above
photograph by the screwdriver).
10) Remove the hood from the
mounting bar and then using a drill bit
with an 8 mm diameter, make holes in
the wall on the positions that you
marked in step 9.
11) Insert rawl plugs into the holes that you have just
drilled.
o Follow steps 7 and 8 again (i.e. rehang the hood
on the mounting bar and then adjust its angle and
height, so that the drilled holes line up with the
lower holes inside the hood again).
o From the inside of the hood, tighten screws into
the holes that you drilled in step 10.
o IMPORTANT: You must fully tighten these screws, as they
assist in fixing the hood to the wall.
22