User manual

42
My appliance isn’t working correctly
Error codes chart
Error
code
Cause Solution
ERR
001
BOILER OVERHEAT
This alarm is caused by the fill
pump being unable to pump
water from the water jug to the
boiler.
The causes may be:-
a) empty pitcher
b) a leak in the hydraulic
circuit
c) a broken pump
d) an electronic failure in the
power circuit.
Check that there is water in the pitcher.
Turn the oven off and then on again
If the failure occurs again, make a note
of the error code and then contact the
Baumatic Service Department, advising
them of this code.
ERR
002
BOILER PROTECTION ALARM Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
003
POWER CARD OVERHEAT Check whether the ventilation
requirements in the installation
instructions have been followed.
Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
004
PT1000 oven cavity sensor fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
005
Food sensor fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
006
Boiler thermocouple fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
007
Oven cavity steam presence
thermocouple fault
Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
008
Oven cavity overheating Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.
ERR
009
NTC sensor fault Make a note of the error code and then
contact the Baumatic Service
Department, advising them of this
code.