User manual

11
Setting and using the oven programmer/timer
Setting the time of day and selecting manual operation mode
After your appliance is connected to your mains supply for the
first time, the numbers on the LCD display will flash 00.00.
Before you can select a cooking function or set a temperature,
at
e
and minus buttons. After 7 seconds, the decimal point on
ll stop flashing and the time of day will be
een
should then be cleaned with
you must set the appliance into “manual operation” mode and
set the time of day.
o To select manual operation mode, press the duration and
cooking end time buttons simultaneously.
o The “A” symbol will disappear from the timer display and the
“manual operation” symbol will appear instead.
o Use the timer plus and minus buttons to adjust the time th
appears in the timer display. The speed at which the time
adjusts is dependant on how hard you press the buttons.
o When the time shown in the timer display is correct, release th
plus
the timer display wi
set.
Before first use
To remove any residue from the oven cavity that may have bo
left from the manufacturing process, you should select the fan
oven function and select its maximum temperature setting.
o It is perfectly normal for a smell to be produced during this
process.
o You should make sure that any windows in the room are left
open during this process.
o It is advisable for you not to remain in the room whilst the
burning off process is taking place.
o You should leave the oven on maximum setting for 30 – 40
minutes.
o After the oven cavity has cooled, it
warm soapy water, using either a sponge or soft cloth. No
abrasive cleaners should be used.