User manual

24
NSTALLATION I
The installation must be carried out by a suitably
erson, in accordance with the current
version of the following.
R m
Repl
o Building Regulations (issued by the Department of the
o ards (issued by the Scottish Development
o gulations.
Be e ake sure that the supply voltage
ma e ith your mains supply
voltage.
o This appliance should be wired into a 30 A double pole switched
n and placed in
an easily accessible position adjacent to the appliance. The spur
inside. Make the connection, securing the cord in place with the
cable clamp provided and then immediately close the terminal
o
e
mains
o If the mains supply cable is damaged, then it must be replaced
o Cable type: H05 RRF 3 core x 2.5 mm²
qualified p
egulations and Safety Standards or their European Nor
acements.
o UK
Environment).
Building Stand
Department).
IEE Wiring Re
o Electricity At Work Regulations.
for connecting the appliance, m
rk d on the Rating Plate corresponds w
WARNING: THIS APPLIANCE MUST BE EARTHED.
fused spur outlet, having 3 mm contact separatio
outlet must still be accessible even when your oven is located in
its housing.
o To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
block cover again.
If you have to change the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than th
line conductors.
o Care must be taken to ensure that the temperature of the
supply cable does not exceed 50°C.
by an appropriate replacement.