User manual

26
hould recheck that the terminal screws are
between the links. This should be done
o
o
Replacing the mains supply cable
If t
suitab
The mains supply cable should be replaced in accordance with the
o he back of the oven.
accordance
w
o If when the oven is first switched on, it does not function
correctly, you s
all fully tightened
before contacting the Baumatic Service Department.
IMPORTANT: The appliance must NOT be connected to the
mains supply by means of a 13A plug and socket.
The cable can be looped if necessary, but make sure that is not
kinked or trapped when the oven is in position. Care must be
taken to avoid the cable being in contact with hot parts of the
appliance.
he a mains supply cable is damaged, then it must be replaced with
le replacement.
following instructions:
o Switch the appliance off at the control switch.
Open the terminal block on t
o Unscrew the terminal screws fixing the cable.
o Replace the cable with one of the same length and in
ith the specification given on page 24.
o The “green-yellow” earth wire must be connected to the terminal
marked . It must be about 10 mm longer than the live and
neutral wires.
marked with letter (N) - the live wire must be connected to the
d to the terminal o The “blue” neutral wire must be connecte
terminal marked with letter (L).