Operation Manual

13
o Restart the machine using the power ON/OFF switch (20).
o You must start the drinks making process right from the
beginning, as stated in the “Using your espresso maker” section
(pages 15 – 17).
3) Filling the water reservoir (auto-fill mode)
o Install the appliance as per the installation instructions contained
in this booklet.
o Open the water reservoir door (14) and remove the water
reservoir (15) from the cabinet.
o Remove the water softener filter (11) from its connecting pipe
and immerse it in a bowl of cold water for five minutes prior to
reconnecting.
o Re-connect the water softener filter (11) to the longest tube and
then place it inside the water reservoir, along with the other two
tubes.
o Put the water reservoir back into the cabinet.
o IMPORTANT: Make sure that the water reservoir is
positioned correctly on the pedal inside the water
reservoir cabinet (as shown in the picture on page
11).
o Switch the appliance on by using the power ON/OFF switch
(20); the power ON indicator (22) will light.
o The reservoir will fill for approximately 40 seconds. During this
operation the low water level indicator (28) will continue to
flash.
o The low water level indicator (28) will remain steady if the
appliance is insufficiently filled. If this occurs, you should switch
off the appliance using the power ON/OFF switch (20) and
restart after a few seconds. The appliance will automatically
commence a further fill of the water reservoir.
o When the water reservoir has been filled sufficiently, the low
water level indicator (28) will go out.
o DO NOT touch any other button on the espresso
machine during this process.