Operation Manual

15
Using your espresso maker
IMPORTANT: Please note that the main boiler and
the steam boiler CANNOT be operated at the same
time.
1) Dispensing hot water through the main boiler
o Follow the instructions on filling the water reservoir as stated
previously and proceed as follows:-
o Press the main boiler activation button (29) to allow the boiler
to heat up. During this process, the main boiler status indicator
(23) will flash.
o When the boiler has reached its operating temperature, the main
boiler status indicator (23) will stop flashing and remain steady.
o Place a cup underneath the filter holder ring nut (19) and then
press the main boiler dispensing button (30).
o To stop hot water from dispensing, press the same button again.
¾ Noise generated during this operation is perfectly
normal. This is caused by the activation of the high
pressure pump during this operation.
¾ It is also quiet normal for a certain amount of water
to drip into the drip tray after water has been
dispensed.
2) Dispensing steam through the steam boiler
o Follow the instructions on filling the water reservoir (pages 11 –
14) as stated previously and proceed as follows:-
o Press the steam boiler activation button (31) to allow the boilers
to heat up. During this process, the steam boiler status indicator
(25) will flash.
o Whilst the steam boiler is heating up, it is normal to get a small
amount of water dripping from the pipe for boiling water and
steam. (17).
o When the boilers have reached their operating temperature, the
steam boiler status indicator (25) will stop flashing and remain
steady.