Operation Manual

29
Connecting the espresso maker to the mains water supply
Your coffee machine can be connected permanently to your mains
water supply.
IMPORTANT: The inlet hose used for connecting the appliance
to the mains water supply should be suitable for supplying
water for human consumption (FDA approved/MIN 5mm- MAX.
12/13mm) and obtained from a DIY or plumbing store.
1. Connect the inlet hose (G3/4")
coupling connecter to the inlet
valve at the rear of the espresso
machine as shown in the opposite
picture. Make sure the connection
is securely tightened.
2. Insert the end of the inlet hose into
the inlet hose coupling that you
connected to the espresso maker in step
1.
3. Feed the inlet hose through a pre-cut hole in the housing
unit before installing the espresso maker.
4. Connect the other inlet hose coupling
to your mains water supply.
Warning: Connect the inlet
hose to water mains
connection fit for human
consumption only.
5. The inlet hose coupling connector
should be hand tightened only.
IMPORTANT: DO NOT over tighten the
inlet hose coupling.