User manual

9) Lift the framework against the ceiling.

The side of the framework shown in the

photograph, is the side that the control

panel will be on when the cooker hood is

connected to the framework.

10) Mark the position of the four

screw holes in the framework on the

ceiling. The positions of the holes are

indicated by the four arrows in the

photograph.

o Remove the framework from

the ceiling.

o Using a drill bit with an 8 mm diametre, drill out the holes that

you have just marked and insert rawlplugs into them.

o IMPORTANT: If you are going to connect the cooker hood to

external ducting, if you have not done so already, then you must

make a hole for the ducting hose to connect to at this point.

(See the “Connecting to external ducting” section on page 23 for

further information regarding the size of the hole that should be

made).

11) IMPORTANT: Do not reinsert the nuts

and bolts that you removed from the upper

plate in step 7.

o Place the upper plate back onto the

framework. You should make sure that

the screw holes in the upper plate are

in the position shown in the

photograph.