User manual

o Fix the whole assembly to the ceiling by tightening screws
through the framework, into the holes that you made in step 10.
o You must make sure that these screws are fully tightened.
12) To reinforce the upper plate, you
should drill into the ceiling, through
the holes on each corner of the upper
plate. The position of one of these
screw holes is shown in the
photograph. You should use an 8 mm
diametre drill bit.
o Insert a rawlplug into each hole.
o Fix the upper plate to the ceiling using screws. You must
ensure that these screws are fully tightened.
IMPORTANT: If you are going to connect your cooker hood to
external ducting, then you must complete the steps listed in the
“Connecting to external ducting” section before carrying on with the
rest of the installation (this section can be found on page 23).
13) Lift the cooker hood towards the framework. One person should
support the hood from underneath, whilst the power cable is
connected as described in the electrical connection information on
pages 15 – 16.
IMPORTANT: THE POWER SUPPLY MUST NOT BE SWITCHED ON
AT THIS STAGE IN THE INSTALLATION.
14) Lift the cooker hood fully over
the framework, locating the
framework into the screw holes
shown in the picture.
o Once the framework is sitting in the holes, secure the cooker
hood to the framework by reinserting and tightening the
screws that you removed in step 3.
o IMPORTANT: You must make sure that these screws are fully
tightened.
21