User manual

Ga
E
o rior to installation, ensure that the gas supply conditions
(nature of the gas and gas pressure) and the adjustment
conditions are compatible. The adjustment conditions for this
appliance are stated on the rating plate which can be found on
the back cover.
ance is not designed to be connected to a combustion
u
to the
o Connection to the cooker should be made with an approved
o or
o A hose length of 0.9m to 1.25m is recommended. The length of
o Care should be taken to ensure that the temperature rise of
tact
.
ple. Light
the other burners and observe that the gas pressure complies
t and
d.
o IMPORTANT: On completion carry out a gas soundness
test.
s connection
ALL INSTALLATION AND SERVICE WORK MUST B
CARRIED OUT BY A CORGI REGISTERED ENGINEER.
P
o This appli
prod ct evacuation device. Particular attention should be given
relevant requirements regarding ventilation.
appliance flexible connection to BS 669.
Models for use with LPG should be fitted with a hose suitable f
LPG and capable of withstanding 50mbar pressure.
hose chosen should be such that when the cooker is in situ, the
hose does not touch the floor.
areas at the rear of the cooker that are likely to come in con
with the flexible hose do not exceed 70°C
o Gas pressure may be checked on a semi-rapid hob burner.
Remove the appropriate injector and attach a test nip
with the gas standards in force.
o This cooker can be connected to the supply both on the righ
left hand side at the rear of the cooker. To reverse the position,
remove the blanking plug and refit it to the opposite side to
where the hose is being connecte
28