User manual

30
inimum flow adjustment for hob gas taps.
All work must be carried out by a CORGI registered
engineer.
o Remove the knob from the tap and
bladed screwdriver
down the centre of the tap shaft.
o Unscrew the adjusting screw, in order to increase the gas flow
ting screw to decrease the gas flow.
tment i o s a
length of about 3 – 4 mm.
o For butane/propane gas, the adjusting screw must be tightly
screwed in.
o Refit the control kn
o Make sure that the flame does not go out by quickly turning
s
flow, testing it again once the adjustment has been made.
M
o Switch the burner on and set the knob at the minimum
position.
place a small
or tighten the adjus
o The correct adjus s btained when the flame ha
ob.
from maximum flow to minimum flow. If it does then remove
the control knob and make further adjustments to the ga