User manual

o Use a screwdriver to remove the 6 fixing screws that hold the
light board in place.
o Prior to touching the light bulbs ensure that they have cooled
down.
o Disconnect the light wiring point (see page 20 for a line drawing
of how to disconnect the light wiring point). Tighten the retaining
ring, push the light out and replace it.
o IMPORTANT: Defective bulbs should be replaced immediately.
o Push the light back into the exposed hole in the hood and
reconnect the light wiring point (see page 21 for a line drawing
that shows how to reconnect the light wiring point).
13