Operation Manual

9) From the inside of the cooker hood, mark the position of the three
lower screw holes that need to be drilled out.
10) Remove the hood from the
mounting bar and then using a drill bit
with an 8 mm diameter, make holes in
the wall on the positions that you have
marked in step 9.
23
11) Insert screw anchors into the three holes that you
have just drilled.
o Follow steps 7 and 8 again (i.e. rehang the hood
on the mounting bar and then adjust its angle until
the drilled holes line up with the three lower holes
inside the hood again).
o From the inside of the hood, tighten three screws
into the lower holes that you have drilled in step
10.