Operation Manual

Fitting the chimney
IMPORTANT: The chimney sections are not supplied
with the appliance. You can purchase the chimney
sections (CQ1SS) from the Baumatic Spares
Department.
13) Take the two chimney
sections (G and H).
o Rest the bottom of
chimney section G on
the top of the hood. You
should take care to
position the tabs on the
chimney section into
the rear of the hood.
o Mark the side
measurement of both
sides of chimney section
G on the wall with a
pencil.
14) Lift chimney section H
upwards until it reaches
the ceiling. You must
ensure that it is
perpendicular to the hood.
o Mark the side
measurement of
both sides of
chimney section H
on the wall with a
pencil and then
remove chimney
section H.
15) Take the fixing bracket (L) and place it between the two pencil
marks that you made in step 13
o Keeping the bracket in contact with the wall, use a pencil to
mark on the wall the anchoring holes that are cut out of the
bracket.
26