User manual

) Changing the LIGHT BULB
9 isconnect the hood from the power supply.
9 off the
grease
9 .
9 After replacing the bulb, put the grease grille back.
_______ ___ __________________________
ou il
he t r
on s
bon filters cannot be cleaned!
a
D
Access the lamp area. Please note that you will have to take
grille at the back to access the lamp area.
Always replace burnt-out bulbs with olive-shaped 40 Watt bulbs
___ ______________________
Y
b) Changing the CARBON FILTER
w l find that one filter will attach over the front of the fan motor (please
see figure at bottom of page).
T ac ive carbon filter must be replaced regularly, at least once every fou
th
m , to allow normal operation when in recirculation mode.
for starting to fit the carbon filter, turn the omni-polar
Be e switch OFF
Changing the Carbon Filter – Note: car
1) Remove the grease filter grilles.
2) Remove the old carbon filter by
twisting it anticlockwise
until it unlatches from the
side of the fan motor.
has two fixing tongues), turning
s sides. (Fig.
4) Replace the anti-grease
NOTE
3) Place the new carbon filter (which
clockwise so that the tongues
latch onto the motor’
3 - left).
metallic filter grilles.
If your filter is different (i.e.
is the Bayonet Circular-
insert type,
Position the filter P in order
to cover the motor
protection grille, ensuring
that the ‘X’ on the filter lines
up with the ‘Y’ on the
conveyor. Then turn
clockwise. Reverse to
dismount
Maintenance – Chan
g
in
g
the Li
g
ht Bulb and Carbon Filter
10