Operating Manual

Manual R600V.DAH5 Multi-object (EN)
R600V.DAH5_multiobject_manual_1.1 (EN).docm Page 9 of 36
Last Update: 01 Jan 2021
Integration Guidance
Mechanical Integration
2.1.1. Objects, Blind-range
The sensor shall be mounted directed towards the area of interest. The sensor opening angle
and angular sensitivity must be considered. Further details can be found in chapter 2.2. The
distance output is relative to the tip of the lens. A blind range of 300mm must be considered.
No measurement is possible within the blind range of the sensor.
The radar reflectance of the material (metal, non-metal, …), its geometry (size, surface struc-
ture, shape) determine the how well objects can be detected. Coatings on the target may
affect the reflectance properties. The reflectance depends on the dielectric constant and con-
ductance of the material at the radar wavelength. Sufficient signal must be validated through
integration testing.
Fig 1 Mechanical Setup (for visualization only)
2.1.2. Reference Target
All data sheet specifications are based on a flat high-reflectance target (a metal plate with
dimensions of 100mm by 100mm). The zero point for the measurement is on the tip of the
lens.
2.1.3. Mounting
A mounting plate with a flatness of better than 0.2mm per 100mm shall be used. Baumer
recommends soft steel as material to match specified mounting torque. For direct mounting
(thread in plate) Baumer recommends a thickness of the steel plate of at least 6mm. For
mounting on a thinner soft steel plates (≥3mm) flange nuts must be used instead.
CAUTION
Installation, mounting and adjustment of this product must only be
executed by skilled and authorized personnel.
300mm
blind
range