Datasheet
Absolute encoders/MAGRES
EAM360R-S - Analog
Solid shaft with synchro flange
Magnetic single- or multiturn encoders
Overview
■
Encoder single- or multiturn / Analog
■
E1 compliant design
■
High protection up to IP 67
■
High resistance to shock and vibrations
■
Protection against corrosion CX (C5-M)
■
Wire cross section 0.5 mm²
■
Teach input for adjustment of measuring range
■
Applicable up to PLd (ISO 13849)
Technical data
Technical data - electrical ratings
Voltage supply 8...30 VDC
14...30 VDC
Reverse polarity protection Yes
Consumption typ. 20 mA (24 VDC, w/o load)
Initializing time ≤ 170 ms after power on
Response time < 1 ms
Interface Analog 0...10 V / 0.5...4.5 V / 4...20 mA /
Resolution: 12 bit
Function Multiturn
Singleturn
Teach range 5°...359.9° (singleturn)
5°...32767 turns (multiturn)
Absolute accuracy ±0,15 ° (+20 ±15 °C)
±0,25 ° (-40...+85 °C) sensor
Accuracy analog output ±0.5 % of whole measuring range (-
40...+85 °C)
Sensing method Magnetic
Interference immunity EN 61000-6-2
ISO 11452-2:2004* / -5:2002*
ISO 7637-2:2004*
ISO 10605:2008 + Amd 1:2014 (CD ±8
kV / AD ±15 kV)
* Severity level according to ECE R10
(Rev. 4)
Emitted interference EN 61000-6-4
CISPR 25:2008 (30...1000 MHz)
ISO 7637-2:2004*
* Severity level according to ECE R10
(Rev. 4)
MTTF
d
(ISO 13849) High (>100 years)
Use in safety functions exclusively based
on Application Note and MTTFd reliability
prediction (request separately).
Technical data - electrical ratings
Programmable parameters Measuring range teachable
Diagnostic function DATAVALID
Factory setting 360° and 10 revolutions (other on request)
Technical data - mechanical design
Size (flange) ø36 mm
Shaft type ø10 x 16 mm, solid shaft with flat
Flange Synchro flange
Protection EN 60529 IP 67 (with shaft seal)
Operating speed ≤6000 rpm
Starting torque ≤2,5 Ncm (+20 °C, IP 67)
Moment of inertia 15,38 gcm²
Admitted shaft load ≤40 N axial
≤80 N radial
Material Housing: steel, powder-coated
Flange: aluminium
Shaft: stainless steel
Corrosion protection IEC 60068-2-52 Salt mist
for ambient conditions CX (C5-M) accord-
ing to ISO 12944-2
Operating temperature -40...+85 °C (see general information)
Relative humidity 95 %
Resistance EN 60068-2-6
Vibration 30 g, 10...2000 Hz
EN 60068-2-27
Shock 500 g, 1 ms
Weight approx. 170 g
Connection Flange connector M12, 5-pin
Cable 2 m
2020-06-22 The product features and technical data specified do not express or imply any warranty. Technical modifications subject to change.
www.baumer.com Data sheet – EAM360R-S - Analog Page 1 of 5