Owner manual

TP10583 PAGE 26
32. Error Screens:
If the choice of fold or paper length created a fold lenghth either over maximum or 14 inches or under minimum
of 2 inches, instead of movement to the new position the Over limits Error screen will be the result. Use the
orange buttons to change to a selection within limits.
If the pans are overcycle moving to home without getting a instruction complete the Rehome pans Screen will
appear. Push the Move Pans Home button to try again. If this doesn't correct the problem there is something
impeding the process.
1. CHECK THAT THE COMMUNICATION CABLE TO THE PAN IS ENGAGED.
2. CHECK THAT THE HOME SWITCH FOR THE PAN IN QUESTION IS ACTIVATING CORRECTLY. ( USE THE TROUBLE
SHOOTING
SCREEN TO MONITOR INPUTS. X3= P2 HOME AND X5=P1 HOME. IF THE HOME SWITCHES ARE
NOT
ACTIVATING CHECK THE POSITION OF THE HOME SWITCH. IF THE POSITION IS CORRECT, CHECK THE 24V
POWER. IF THE POWER IS CORRECT, REPLACE THE HOME SWITCH.)
3. CHECK SETSCREW ON COLLAR CONNECTING THE PAN MOTOR TO THE LEAD SCREW . IF LEAD SCREW IS
MISALIGNED
LOOSEN THE SET SCREW, MOVE LEAD SCREW UNTIL ALIGNED, THEN RETIGHTEN.
4. IF NONE OF THESE HELP, CHECK THE 12V POWER SUPPLY. CEHCK F12. THE POWER LED ON THE A1
STEPPER BOARD. THEN CHECK THE CONNECTIONS ARE GOOD ON THE A1 SLEW CONNECTION AND THE
OUTPUTS
Y OF THE PLC. CHECK THE A1 Y CONNECTOR FOR PAN 2 AND THE A1 X CONNECTOR FOR PAN 1.
IF ALL OF THESE ARE GOOD, THE PAN MOTOR NEEDS TO BE REPLACED.