Owner manual

PAGE 33 TP10583
Note: The postion of the deflector will need to be adjusted in this
same manner any time the home position of the paper stop is
changed by making adjustments to the paper stop screws. If
this is not corrected each time these screws are adjusted,
serious damage to the folder or fold pans may occur!
R.) Turn the handwheel of the machine and listen and feel for any rubbing
of the #2 pan’s deflector on the rolls. If there is not any rubbing of the
deflector on the fold rolls proceed to Step #3.
Before proceeding with calibration of the fold pans, you must ensure that the sheets are
being fed into the fold rolls squarely and that the sheets are hitting both paper stops of the
new fold pans squarely. These new pans are calibrated with
8 1/2 x 11” 20# Bond copier paper. We use this stock since it is a common stock used in
the tabletop folders.
3.) Ensure the paper is being fed into the fold rolls squarely:
A.) Turn power off to the machine.
B.) Remove the #1 fold pan.
C.) Place a single sheet of paper into the feeder.
D.) Move the non-operator side guide away from the sheet.
E.) Manually feed the single sheet of paper by hand until it enters the nip
of the fold rolls. Make sure that the sheet does not pull away from the
operator side guide.
F.) At this point you should be able to turn the handwheel and the sheet
should become visible on the exit side of the Main and #1 fold rolls.
G.) Compare the amount of paper now sticking out of the fold rolls on
both the operator and non-operator sides.
-If the amount is equal, then this means that the operator side guide
of the feeder is feeding the sheet square to the fold rolls. Proceed to
Step #3.N.
-If the amount is not equal, then this means that the operator side
guide of the feeder is not feeding the sheet square to the fold rolls
and the operator side guide will need to be adjusted. Proceed to
Step #3.H.