bavarianDEMON AXON Manual V1.5

TRIMMING

Using an electronic head stabilization, trim adjustment on the transmitter is not allowed (and not necessary). The system interprets

any trim as a control input.

Helicopters equipped with ybar, even though they would not need an electronic head stabilization, can still use it in order to correct

any minor trim differences and drifts. To do so, start with very low head gain and increase carefully.

FAILSAFE

There are 3 options for the failsafe settings, and for each channel of Coll.pitch, throttle, Horizon and AUX separately:

BLANK: no failsafe action by the system

HOLD (Factory default): the last properly received signal will be held

FIX: a personally dened failsafe value/signal can be set, by adjusting the parameter, appearing below the channel assignment, to the

desired value. Alternatively, you can teach all 4 from the radio currently received parameter values by clicking ‚learn failsafe values‘.

ATTENTION: All 4 values will be teached, even if one or more parameter are not set to FIX. In case, set the channels, that are not

meant to be FIX, back to the desired option.

Note: The internal failsafe will only be activated, if there is no „proper“ signal received from the receiver (e.g. connection cut between

receiver and system). Thus, if there is a failure in the link between transmitter and receiver, and the receiver‘s failsafe is activated, the

system‘s failsafe will not activate.