bavarianDEMON AXON Manual V1.5

• Never use the governor port to supply power to the system! It could take severe damage.
• Do not connect servos until the device has been set to the correct servo type via software.
• Do not move the model/device for the rst few seconds after powering on (LED ashes red). The system runs a self-test and needs
standstill to perform this, as otherwise it will not initialize, activate the servos, and start to ash 3x red power-cycle.
• When using the cable loom: route all cables as a common bundle. Single wires must not lie separately.
• The additional channels for head gyro, tail gyro, and horizon modes serve to set the respective gain (sensitivity) and mode in ight.
A potentiometer or slider on the transmitter should be assigned one each for the gain channels. As an alternative, and recommended
for nal set-up, a xed value can be programmed on a switch, the radio’s gyro menu can be used, or the values can be set in the
software (in this case, the corresponding channel must not see a transmitter input).
OPERATION
Do not move model and sticks during initialization after power-on.
The status of initialization can be seen on the servo‘s reaction: are
these not following any Tx inputs, or does the LED not light up cons-
tantly, one of the following errors shows up:
Waiting for input signal: LED pulses red
Failure: system not initialized due to movement!
After successful initialization, servos respond to stick inputs and gyro
corrections when tilting the helicopter.
Constant LED light ready for operation
GYRO MODE
Bank yellow
Bank blue
Bank red
Horizon mode: contant green LED light
Rescue mode: LED ickers green
LED DISPLAY
6