Unit installation

12. CERAMIC PEBBLES INSTALLATION
This section is for models supplied with a ‘Pebble’ fuel effect only.
For ‘Coal fuel effect’ see section 11.
12.1 Ceramic Pebble fuel effect installation for Chic model.
The ceramic fuel effect may cause staining /
discolouration to decorative surfaces. It is therefore
advisable to protect decorative surfaces.
1. Fit the ceramic pebble base into the fire above the
burner. The front of the ceramic pebble base should
locate on the horizontal faces but behind the vertical
faces of the two location brackets positioned at the front
of the burner module (See figure 26).
The pebbles should be positioned so that the arrows
always point towards the back of the firebox. When
located into position the stem of each arrow should be at
90° to the rear of the firebox.
2. Hold pebble ‘A’ upright with the arrow pointing to the
top. Locate pebble ‘A’ as
shown in figure 27.
Page 31
© Baxi Heating U.K. Limited 2009.
Figure 27.
Figure 26. Ceramic pebble
base location
INSTALLER GUIDE