Unit installation

15. FASCIA FITTING
If you have not done so already complete the
information on the last pages of this guide.
15.1 Fitting the Decadent fascia
 Remove any protective film from the fascia.
 Locate the two lugs at the top of the fascia in
the slots in the convection box hood. Swing the
bottom of the fascia sides back against the
convection box and lower the fascia so that the
lugs are fully seated in the slots in the convection
box hood (See figure 34).
 Refit the two screws to secure the bottom of
the fascia sides to the convection box side
brackets.
 Check that the two screws in the back of
the fire front casting are in the inner threaded
holes. If they are in the outer holes, relocate
them (See figure 35)
 Fit the fire front casting between the fascia
sides. Where fitted to the casting, locate the
two screw heads at the rear top corners of
the casting through the keyhole slots at the
inner sides of the fascia. If the screw heads
do not project enough or project too far, the
screws can be adjusted.
 Lower the casting so that it rests on the
hearth (See figure 36).
 Fit the "ash pan" cover below the front
casting locating it as shown in figure 37.
Page 35
© Baxi Heating U.K. Limited 2009.
Figure 37. Ash pan location
Figure 36. Fire front casting location
Figure 35 Casting screw position.
Figure 34. Fascia fitting (Fascia
may differ from that shown)
INSTALLER GUIDE