Unit installation

15.2 Fitting the Chic fascia.

 Supplied with the fire is a controls heat baffle and

three edge clips. These must be fitted to the heat engine

before fitting the Chic fascia. Locate and secure the

baffle as in figure 38.

 Remove any protective film from the fascia.

 Locate the two lugs at the top of the fascia in the

slots in the convection box hood. Swing the bottom of

the fascia sides back against the convection box and

lower the fascia so that the lugs are fully seated in the

slots in the convection box hood (See figure 39).

 Secure the bottom of the fascia sides to the

convection box side brackets using the two screws

removed previously (See figure 39).

 Secure the top of the fascia to the convection box

using the two screws removed

previously (See figure 40).

Page 36

INSTALLER GUIDE

Figure 40. Securing

the ‘Chic’ fascia to the

heat baffle

Figure 39. Fascia securing

Figure 38. Fitting the baffle