Unit installation

 Unscrew and remove the two screws

that secure the bottom of the fascia

sides to the convection box (See figure

47).

 Remove the wiring loom connectors

from the left hand side of the gas valve.

 Raise the fascia to allow the retaining

lugs at the top to clear the slots in the

convection box hood and then lift clear

(See figure 47). Be careful not trap the

wiring loom when lifting clear.

Dream

 Remove the ash pan cover.

 Remove the firefront casting.

 Remove the wiring loom connectors

from the left hand side of the gas valve.

 Remove the two screws securing the

bottom of the fascia to the sides of the

convection box.

 Raise the fascia to allow the retaining lugs at the top

to clear the slots in the convection box hood and then

lift clear (See figure 43). Be careful not trap the wiring

loom when lifting clear.

17.2 To remove or clean the window unit.

 Remove the fascia (See section 17.1).

 Unscrew and remove the three spring-loaded

window-fixing screws and bushes from the base of the

window frame (See figure 48).

 Gently swing the base of the window frame forward

while lifting the frame upward. The window should lift

clear of the fire. Put the window in a safe place away

from your immediate work area.

 Any stains on the glass can be removed with a non-

abrasive cleaner such as a ceramic hob cleaner. Never

use abrasive cleaners. Clean the window carefully in accordance with the instructions

supplied with the cleaner.

 Replace the window making sure that the seal around the frame is not damaged

or misplaced. Locate the channel at the top of the window over the top of the firebox

opening.

 Refit the three spring-loaded screws and bushes. The wide part of the bushes

Page 41

Figure 48. Window fixing

Figure 47.

INSTALLER GUIDE