Unit installation

 Press firmly inward the two retaining claws on the inside of the rocker switch.
Remove the loom through the switch aperture in the case side.
 Replace in the reverse order.
 When replacing the switch make sure that the white printing on the switch side
faces the back of the fire. If the printing faces the front, pressing the upper half of the
switch will lower the flame height.
 When replacing, make sure that the wiring loom runs above and down to the right
of the battery box and behind the control valve (See figure 55).
 Secure the loom to the battery box bracket with the cable tie supplied with the new
loom - check that there is sufficient free length of loom wire to allow the battery holder
to be removed from & replaced in the battery box before securing the cable tie.
 The motor lead connectors are two different sizes. They will only fit to the correct
motor terminals.
Page 45
© Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
Figure 55. Wiring diagram.