Operating instructions

7.0 Fault Finding/Emergency
10
7.1 Check List
1. If a fault develops, or is suspected, call a Competent
Person as soon as possible.
2. Go through the following check list before you make
contact.
a) Is the electricity supply on ?
c) Is the Red “Fault” light illuminated ?
If the boiler fails to light or the boiler is running and
the gas is turned off, the light will start to flash red.
Press the reset button (Do Not use excessive
pressure), the light will stop flashing and the boiler
will attempt to relight. If the boiler will not light it
should be attended to by a competent person.
d) Is the gas supply on ?
e) Is the boiler temperature control set high enough ?
f) Is the time clock (if fitted) on ?
g) Is the room thermostat (if fitted) set high enough ?
h) Are the radiator valves open ?
7.2 IN AN EMERGENCY
If a water or gas leak occurs or is suspected, the boiler can
be isolated at the inlet valves as follows;
1. Turn off the electrical supply.
2. The isolating valves are positioned under the boiler and
can be closed using either a flat headed screwdriver or a
7mm open ended spanner across the flats.
3. Turn the gas tap clockwise to the stop position to
isolate the gas supply at the boiler.
4. To isolate the water system, close the four valves fully
by turning clockwise.
5. Call a Competent Person as soon as possible.